Arm Clamps for 67 Designs Arms

Installation is Easy.

• Undo the included fasteners and attach to a 67 Designs' carbon fiber arm (not included) and any existing hardware that has a 1 inch ball.

• Installs in seconds. 

Benefits

• Mix and match holders and devices. Reuse prior investment in other vendor's bases and device holders that may have a 20mm or 25.4mm (1") diameter ball.

• Add an clamp set to the end of a 67 Designs' arm "core" and you can then attach a complete arm to a holder or base from another manufacturer.

• Cast metal for years of service.

Available Packs

The options to connect a 67 Designs carbon fiber series "core" to 20mm and 25.4mm (1") ball hardware are as follows:

• 1 x 20mm clamp.
• 2 x 20mm clamp sets.
• 1 x 20mm arm clamp and 1 x 25.4mm (1") arm clamp.
• 1 x 25.4mm (1") clamp sets.
• 2 x 25.4mm (1") clamp sets.

Note: An arm clamp includes 2 x aluminum castings + 1 x nylon thumb nut + 1 x 6mm black stainless steel bolt. An arm requires two arm clamps.

CAUTION: Not designed to work with any other manufacturer arms. Only works with 67 Designs "cores". Using with non-67 Designs arms voids the warranty.

Important Generation 1 "G1" and Generation 2 "G2" information.

• The Dam Adapter™ G2 castings ("non-ribbed")will fit the Carbon Fiber Arms G1 segments.

• The Dam Adapter™ G1 castings ("ribbed") will NOT fit all Carbon Fiber Arms G2 segments.

• If you purchased a 67 Designs pre-configured Pack or individual Carbon Fiber Arms after March 13th, 2021 almost certainly you will have been shipped the Carbon Fiber Arms G2.

• If you have any doubts about which version to purchase, please contact Customer Service before ordering.

• If you are looking to order the G1 'ribbed' version of the Dam Adapter, please contact Customer Service.

• Bases, carbon fiber arms, holders and devices shown in the images on this page are for reference only and must be purchased separately.